It’s not news that standard-issue table saw miter gauges are often sub-standard. The bar wiggles in the slot and it can be nearly impossible to accurately set the head. That’s why woodworkers upgrade their miter gauges.
I recently tested the Osborne EB-3 miter gauge, $120. Here’s what I learned.
The EB-3 uses a unique triangle system. It looks like a shelf bracket. The concept makes sense, since we all know how strong shelf brackets are. Osborne strives to have every EB-3 dead on right out of the box. If a tweak does need to be made to zero the miter gauge, it’s easy to do.
The Osborne miter gauge can be used on either side of the blade, left or right tilt saw. It takes a minute or two of disassembly and reassembly to make the change.
Preset angles (0-45 in 5-degree increments left and right, plus 22.5 left and right) are hit by loosening the thumbscrew and depressing a plunger on the bottom of the outer brace while you move the inner brace. The plunger will hit detents at the presets.
The miter gauge bar is snugged to the slot by adjusting it from above with the bar in the saw. This is a great approach for making this adjustment, allowing accurate fine tuning. Some miter gauges require you to make adjustments with the bar out of the saw slot, then reinsert it to test your work. It’s hard to get good results that way. I much prefer the method used by the EB-3.
The bar will fit a miter gauge slot as small as .741” and expand to fit slots up to .765” wide.
The fence extension and flip stop, included, projects far enough from the miter gauge to provide a 40” long cut on my SawStop table saw. This amount will vary from saw to saw, but that’s a lot of capacity. The flip stop can also be used on the main body of the fence.
Thoughts on the EB-3
The EB-3 is a solid miter gauge. If you frequently cross cut long items on your table saw you’ll find that the triangular support does a great job of preventing the miter gauge head from torqueing away from your angle setting. Detents for preset angles were accurate in both directions.
It was very easy, using the three expansion slots in the bar, to customize the bar width for my saw, creating a perfect fit.
The significant support and flip stop capacity provided by the extension is great. Very few miter gauges extend as far as this one does.
If you want to add an auxiliary fence to the EB-3 you’ll have to drill through the aluminum extrusion fence to do so. While this wouldn’t be horribly difficult to do, I’d like to see Osborne include these holes as part of the manufacturing process.
When going for angles not covered by the detents I found it a little difficult to be precise, compared to my work with protractor-style miter gauges.
This Osborne miter gauge will add accuracy to your table saw. The parts are well machined and it has the feel of a quality piece of equipment. It’s also priced well within the aftermarket miter gauge category.
Osborne EB-3 Miter Gauge